Find Helpful Plumbing Tips from the Leaders at Milani
Read the following plumber tips and learn how you can diagnose and solve problems within your plumbing system. Remember, if the situation calls for more than a simple fix, it’s always best to turn to the professionals at Milani Plumbing, Heating & Air Conditioning. Improper repairs can lead to costly damage.
Pipe noises range from loud hammering sounds to high-pitched squeaks. The causes may be loose pipes, water logged air chambers, or water pressure that’s too high. Anchoring exposed pipes is a simple solution; other remedies such as anchoring pipes concealed inside walls, floors or ceilings, may call for a professional.
This noise occurs when you turn off the water at a faucet or an appliance quickly. The water flowing through the pipes slams to a stop, causing a hammering noise. Check for loose pipes and secure them to the wooden floor joists. Other potential problems could be air chambers within your water piping system or a high water pressure problem.
A higher than normal water bill might be your first indication of a leaking pipe. Or you might hear the sound of running water even when all your fixtures are turned off. When you suspect a leak, check the fixtures first to make sure all the faucets are tightly closed. Then go to the water meter, if you have one. If the dial is moving, you’re losing water somewhere in the system.
The sound of running water helps. If you hear it, follow it to its source. You can buy a listening device that amplifies sounds when it’s held up to a pipe. Any wall stain is likely to be below the actual location of the leak and you’ll probably need to remove part of the wall to find it. Remember, if water is staining the ceiling or dripping down, the leak is probably directly above.
A faucet that won’t yield water is the first sign of frozen pipes. If a severe cold snap hits, prevent freezing and subsequent bursting of pipes by following the suggestions below. Even if the pipes do freeze, you can thaw them before they burst if you act quickly. When temperatures fall very low, here’s how to keep your pipes from freezing:
Keep a trickle of water running from the faucets.
- Beam a heat lamp or small heater at exposed pipes (hair dryers work well too).
- Wrap un-insulated pipes with newspapers, foam pipe insulation, or self-adhesive insulating tape.
- Keep cabinets open and doors ajar between heated and unheated rooms
- Shower Heads
- Erratic or weak pressure usually indicates mineral buildup. To restore proper flow, clean outlet holes with a pin or unscrew the perforated face plate and soak it overnight in vinegar, then scrub it clean with an old toothbrush.
Sink Sprays & Diverters
A kitchen sink spray has a spray head attached to a hose, which is connected to a diverter valve in the faucet body. When you squeeze the spray head handle, the diverter valve reroutes water from the faucet to the spray head hose. If the flow is sluggish, make sure the hose isn’t kinked. Clean the aerator in the spray nozzle. Continued sluggishness may indicate diverter valve problems.
If water is leaking from your water heater check the drain valve at the base of the tank, temperature & pressure valve on the side of the tank, hole in the tank or a leak on a plumbing connection.
If your hot water is rusty or discolored this could be the result of an accumulation of rust or sediment in the tank. Other potential problems could be scale on the heating elements or a corroded water pipe.
If you do not have enough hot water there could be a quite a few potential problems. For a gas water heater, the pilot light may be out, sediment may have formed in the tank or the burner may be clogged. Otherwise, you may have a faulty thermocouple or gas valve. For an electric water heater, the temperature control may be set too low. Otherwise it’s generally a faulty heating element or thermostat. Of course, it could just be that the hot water tank itself is too small.